Understanding Golf Putting Basics

Putting is the stroke used on the green when the ball is close to the hole. It accounts for roughly 40 percent of all strokes in a round of golf, making it one of the most important aspects of the game. A typical golfer takes between 30 and 40 putts per round, while professional golfers average around 27 to 29 putts. This difference illustrates how much skill development in putting can lower your overall score.

Your Free Guide to UCHealth Billing Contact Information →

The putting stroke differs significantly from a full golf swing. Instead of using large muscle groups and rotating your body, putting relies on smaller, more controlled movements. The putter is the shortest club in your bag, typically ranging from 33 to 35 inches in length. The putter head comes in different shapes—blade putters have a thin, flat design, while mallet putters are larger and more forgiving. Many golfers find mallet putters easier to control because they have a higher moment of inertia, meaning they resist twisting when you miss the center of the club face.

Understanding green conditions is equally important. Greens vary in grass type, moisture level, slope, and firmness. Bent grass greens, common in northern climates, tend to be smoother and faster than bermuda grass greens found in warmer regions. The speed of a green is measured by how far a ball rolls after being struck, and this is tested using a device called a stimpmeter. A green with a Stimp reading of 12 feet means a ball will roll approximately 12 feet after being tapped lightly.

Practical takeaway: Visit a local putting green or practice area and spend 15 minutes observing how the ball rolls on different parts of the green. Notice how terrain changes affect the ball's path and speed.

Grip and Stance Fundamentals

Your grip on the putter is the foundation for consistency. Unlike a full swing grip, putting grips should feel relaxed and secure without excessive tension. Most golfers use either the reverse overlap grip or the cross-handed grip. In the reverse overlap grip, your left hand (for right-handed golfers) holds the putter handle with your left index finger overlapping the fingers of your right hand. This grip promotes a unified motion where both hands work together smoothly.

Learn How to Pay Your Indiana University Health Bill →

The cross-handed grip, also called left-hand low for right-handed golfers, places your left hand below your right hand on the putter. This grip became popular because it naturally encourages the shoulders to stay square to the target line throughout the stroke. Studies on professional golfers show that approximately 15 percent of PGA Tour players use a variation of cross-handed putting, suggesting this method can be effective at the highest levels of competition.

Grip pressure matters significantly. Many golfers grip the putter too tightly, creating tension that transfers to their arms and shoulders. A proper grip pressure feels like holding a small bird—firm enough that it doesn't fly away, but gentle enough that you don't harm it. On a scale of one to ten, aim for a pressure level of about four or five. This allows your wrists to remain flexible and your stroke to flow smoothly.

Your stance involves how you position your feet, body alignment, and posture. A typical putting stance has your feet shoulder-width apart, with your weight distributed evenly. Your shoulders should be perpendicular to the target line. Many instructors recommend positioning your eyes directly over the ball or slightly inside the target line. This positioning helps you see the line more clearly and makes it easier to swing the putter straight back and through.

Practical takeaway: Practice your grip and stance without hitting balls. Stand over a ball on a practice green and hold your setup for 30 seconds, focusing on relaxed grip pressure and balanced weight distribution.

Reading Greens and Understanding Break

Reading the green—determining how the ball will curve from your ball to the hole—is a skill that improves with practice and experience. Break refers to the slope of the green that causes the ball to curve. A putt breaking left means the green slopes downward toward the left side. The amount of break depends on several factors: the degree of slope, the speed of the green, and the distance the ball travels.

Your Free Guide to Keeping Poinsettias Healthy and Blooming →

Professional golfers use a systematic approach to read greens. They typically observe the green from multiple angles. Standing behind the ball looking toward the hole gives you one perspective. Walking around to look from behind the hole provides another view. Some golfers crouch down to get a perspective closer to the ground, where slopes become more apparent. This process takes 20 to 30 seconds for most tour players.

Understanding slope categories helps organize what you're seeing. A putt with minimal break is relatively straightforward—you aim directly at the hole. A putt with moderate break (curving several inches) requires you to aim to the side of the hole, called the aimpoint. For example, if a putt breaks six inches left over a distance of 15 feet, you might aim three feet to the right of the hole to allow the ball to curve in. A putt with severe break might move more than a foot, significantly altering your aiming line.

The Stimp rating of the green affects how much break influences the ball. On slower greens with a Stimp rating of 10, the ball doesn't roll as far, so gravity has less time to pull it off line. On faster greens with a Stimp rating of 13 or higher, the ball rolls farther and curves more dramatically. Professional courses often maintain greens at a Stimp rating of 11 to 13 during tournaments.

Practical takeaway: On your next round, pick three putts of different lengths and distances from the hole. For each putt, observe from multiple angles and estimate the break direction and distance before you putt. After putting, note whether your read was accurate.

The Putting Stroke Mechanics

The putting stroke should be a simple, repeatable motion that moves the putter straight back and straight through toward the target line. Think of it as a pendulum attached to your shoulders. The motion originates from your shoulders and upper arms, not from your wrists or hands. The putter should stay low to the ground throughout the entire stroke, moving along the target line without twisting or opening.

Free Guide to Managing Ear Infection Symptoms at Home →

The backstroke is the initial movement away from the ball. For short putts under five feet, the backstroke is minimal—perhaps just a few inches. For medium putts of 5 to 20 feet, the backstroke extends further. For longer putts beyond 20 feet, the backstroke becomes longer still. The length of your backstroke should roughly equal the length of your forward stroke. This creates rhythm and consistency. Many putting instructors teach that the backstroke and forward stroke should take the same amount of time, creating a metronome-like tempo.

The forward stroke is where the energy transfers to the ball. The putter accelerates through the ball rather than decelerating at impact. This produces a smooth roll with consistent distance control. A common mistake is decelerating into the ball, which causes the ball to hop rather than roll smoothly. Tour players typically contact the ball at the same pressure point on the putter face, usually the sweet spot or center of the clubface.

The follow-through continues naturally from the forward stroke. Your putter should swing past the ball, finishing with the putter head traveling along the target line. The follow-through mirrors the backstroke in length and tempo. Your head should remain still throughout the entire stroke, keeping your eyes focused on where the ball was positioned. Many golfers look up too early, which disrupts their stroke and prevents them from following through properly.

Practical takeaway: Practice the pendulum motion without a ball. Make 20 slow, deliberate putting strokes focusing only on a smooth, even tempo with matching backstroke and forward stroke lengths.

Distance Control and Lag Putting

Distance control determines how far your putt travels, and it's especially important on long putts. The goal on putts longer than 10 to 15 feet is not necessarily to make them but to leave yourself a short putt for your next stroke. This is called lag putting. Studies show that professional golfers make approximately 99 percent of putts from three feet or closer, but only about 50 percent of putts from 10 feet. The percentages drop significantly as distance increases—professionals make only about 20 percent of putts from 25 feet.

Free Guide to Finding Your Medical Records →

Controlling distance relies on controlling the length and speed of your stroke. Your backstroke length correlates with